Selection Considerations
Select listed ID/OD combinations
Evaluate fluid or bubble visibility with the actual tubing
Confirm fittings and temperature-pressure conditions together

FEP (fluorinated ethylene propylene) tubing, also known as F46 tubing, offers good chemical resistance. Clear tubing allows liquids and bubbles to be observed and is commonly used in reagent, sample and wash-fluid lines where visual inspection of the fluid is needed. Compared with PTFE, FEP generally offers greater optical clarity. Compare gas permeability for the target gas under matched conditions, including wall thickness and temperature.
Inner diameters range from 0.3–2.0 mm and outer diameters from 1.6–3.2 mm, with ID/OD combinations matched to the listed sizes. Tubing is available by the roll or as flanged, retaining-ring or ferrule tubing assemblies. Ferrule connections do not require pre-flanging. Connection configurations for tubing ODs of 1.6, 2.0, 2.5, 3.0 and 3.2 mm can be matched to the selected size, with tubing length and fittings at ends A and B customized to drawings.
FOREACH holds ISO 9001 and ISO 13485 quality management system certifications and supports sample testing. The availability of compliance documentation, including RoHS reports, is confirmed for the selected model and project requirements. When clear FEP tubing is used for bubble detection, verify detection performance with the selected sensor model, tubing dimensions and actual fluid. 200 °C is a reference temperature limit for the material; the actual operating range depends on the temperature and pressure limits of both the tubing and fittings.
Typical Applications:
Reagent and sample lines requiring visual observation of liquids or bubbles, Small-bore sample introduction connections, Wash-fluid lines
| Density (g/cm³) | 2.13 |
|---|---|
| Tensile Strength (MPa) | 27.6 |
| Flexural Strength (MPa) | 18.5 (ASTM D790) |
| Dielectric Strength (kV/mm) | 2.1 (IEC60243-1) |
| Water Absorption (%) | <0.01 (ASTM D570) |
| Hardness (Shore D) | 50, 60 |
| Operating Temperature (℃) | -230~200 |
| Coefficient of Thermal Expansion (cm/cm/°C) | 9.9X10⁻⁵ |
| Melting Temperature (°C) | 260 |
| Low-Temperature Brittleness (°C) | -250 |
Select listed ID/OD combinations
Evaluate fluid or bubble visibility with the actual tubing
Confirm fittings and temperature-pressure conditions together
Reagent and sample lines requiring visual observation of liquids or bubbles
Small-bore sample introduction connections
Wash-fluid lines
Select flat-bottom or compression connections around OD, tolerance and the fitting specifications. Check the thread, sealing geometry and materials. Prepare the tube end as specified and confirm pressure derating for elevated-temperature operation.
The datasheet for this product has not been uploaded yet.
FEP often offers better visibility of fluid. Compare the actual appearance, dimensions, fluid and connections; material names alone do not establish tolerance or pressure capability.
Share the fluid and concentration, ID/OD, length, temperature, pressure or vacuum, fittings and routing requirements so Foreach can help review the FEP tubing and connection options.