Where waste handling and cleaning fit in the instrument
Tubing and fittings form the actual connections for samples, wash liquids and discarded liquids, defining destinations, shared sections and maintenance access. The installed drive provides suction/drainage power; connection components do not generate suction themselves.
Distinguish vessels for retained samples, discarded wash liquid and final waste. Check assembly, sealing and retained volume. After maintenance, measure actual drainage and the next sample's blank before resuming automated transfer.
Product responsibilities in this operation
Tubing, fittings and the protection components described here form the actual path. Validate materials, passage dimensions, connection volume and maintenance state with this operation.
For environmental sample preparation, define sample and cleaning-liquid waste destinations, shared paths, peak drainage and maintenance requirements.
Organize the sequence by actual architecture
- This task concerns wetted paths and destinations. Identify retained samples, wash discard and waste vessels for the samples and cleaning agents, confirming materials and serviceable sections.
- Use separately configured supply and drainage pumps to perform permitted washing. Check connection sealing, shared-path residue and vessel states. Tubing and fittings themselves do not provide pumping power.
- Recheck actual paths after maintenance. Use a blank or the next sample to assess recovery, and confirm correct destinations and absence of unacceptable wash residue before resuming preparation.
Define operating conditions for this task
| To define | Details |
|---|---|
| Actual operating conditions | Sample and wash-waste destinations, shared paths, peak drainage and maintenance requirements |
| Acceptance target | Measure actual drainage and vessel protection, then use a blank or the next sample to verify shared-path washing recovery |
| Fault localization | Incorrect waste routing, accumulated liquid or cleaning residue can contaminate the next sample. |
Compare product configurations by the roles on this page
| Product | Configuration option | Conditions to verify |
|---|---|---|
| Tubing materials and dimensions | Connection paths and shared volume | Bore, length, load and actual formulation jointly determine materials and dimensions |
| Rigid-tubing fittings | Tube-end positioning and sealed connections | Check tube outer diameter, threads, seal structure and port-bottom geometry |
Validate operation results at the receiver
Measure actual drainage and vessel protection, then use a blank or the next sample to verify shared-path washing recovery.
Evaluate blanks, recovery, aliquot representativeness and restart according to the method.
Locate abnormalities and restore the next operation
Incorrect waste routing, accumulated liquid or cleaning residue can contaminate the next sample.
Stop supply and resolve waste-removal abnormalities; check the full cycle after recovery.
Dilution metering can share general engineering methods, but field preservation, particles and analyte loss require separate checks.