1. Higher-Flow Waste Liquid Pump for IVD and Analytical Instruments
In IVD and analytical instruments, waste liquid may need to be removed from reaction vessels, wash stations or collection manifolds within a limited process time. When the volume per cycle is higher or the drain step must be shorter, a 600 mL/min-class waste liquid pump provides more transfer capacity than a 300 mL/min-class pump.
The 600 mL/min value is a no-load reference, not the guaranteed drainage rate after installation. Suction lift, tubing ID, valves, filters and discharge back pressure must be included when determining whether the required waste-removal time can be achieved.
2. Wash and Rinse Pump for Laboratory Automation
Laboratory automation equipment may need to replace wash liquid quickly between samples, rinse probes or flow cells, or flush internal tubing after a process step. In these fluid paths the pump is commonly used as a wash solution pump or rinse pump rather than a precision dosing pump.
A 600 mL/min flow class can shorten liquid-exchange time when the tubing and downstream components allow the required flow. The 3 mH₂O self-priming specification can assist startup and bottle replacement, but a long or restrictive suction line can reduce the available flow.
3. Waste and Rinse Pump for Water and Environmental Analyzers
Online water-quality and environmental analyzers often repeat sample intake, internal rinsing and waste discharge throughout a measurement cycle. A higher-flow diaphragm liquid pump can be used in auxiliary rinse and waste paths when faster cleaning or larger liquid volumes are required.
When used with acids, alkalis, oxidizing solutions or other special media, the complete wetted-material set must be checked against concentration, temperature and contact time. High-accuracy reagent dosing should still be handled by a suitable metering technology.
4. Auxiliary Liquid Circulation Pump for Instrument Systems
Some instrument fluid paths require continuous or periodic low-pressure circulation to keep wash solution, service fluid or another compatible liquid moving between a reservoir and an internal module. In this position a 600 mL/min-class diaphragm pump can serve as an auxiliary liquid circulation pump.
This is not a high-pressure circulation pump. Actual circulation rate depends on the full circuit resistance, and the 100 kPa rated-pressure specification must not be interpreted as 600 mL/min at 100 kPa. Read the flow-pressure curve at the required operating point.
5. Automatic Refill Pump for Larger Auxiliary Reservoirs
Where an instrument uses a larger wash or service-fluid reservoir, a small automatic refill pump can restore the local level from a lower supply container. Compared with a 300 mL/min-class pump, the 600 mL/min class can reduce refill time when the fluid path has low enough resistance.
The 3 mH₂O self-priming specification helps with moderate level differences, but actual refill performance depends on fluid viscosity, suction-line length, filter resistance, discharge pressure and material compatibility.